This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
Text excerpt from page 2 (click to view)
4-48
Forsyningsspeqdingetr En pil og spandingen viser, hvor forsyningsspendiqgerne gfr ind i et prinl Eksempel: (7 CON.) feks. ved siden af forsyningsspendingen angiver det antal stedet, spandingen gtr ind pi denne diagramside.
\
4-48
Supply Voltage An arrow and the voltage show where the supply voltages are fed to a PCB. Example: (7 CON.) next to the supply voltage indicates the number of places where to find the voltages in this diagram.
Symbol for sikkerhedskomponenter
d-
for Safety Components
Ved udskiftrting af komponenter med dette symbol skal der anvends komponenter med samme reservedelsnummer. Den nye komponent skal monteres pi sammemtde som den udskiftede.
When replacing componentswith this symbol components with identical part numbers are to be used. The new component must be fitted in the same way as the one replaced
uArJBBrnqCBrsBn
Alle DC spandinger er milt i forhold til stel, med voltrneter med en indgangsmodstandpA 10 Mohm. Spendingerne er milt uden signaltilforing.
MEAST'RING coNDITIoNS
All DC voltages have been measured in relation to ground with voltneter with an input resistance of 10 Mohms. The voltages have been measured without any supply of signal.